Monumental Designs instaling a sign.

Home

Models

Ordering Info

Installation

installation. We have added this section after many inquiries about how difficult it is to install one of these signs. The short answer..... simple, the long answer..... well, I will just show you a step-by-step of one of these signs going up. In this example the situation called for a little more work than what is usually necessary for a standard install. The original signs for a subdivision needed to be replaced but the original stone post and concrete foundation needed to stay.
step1. This shows one of the 4 original entryway signs of this sub-division. The original sandblasted signs are suspended between two stone columns. These columns will stay and stucco monument will rest in between. In most cases there is not a pair of stone posts and a concrete foundation to deal with.
step2. After cutting out the old signs the foundation was cleared out to make room for the posts.
step3. PVC pipes are used to hold the sign in place. Here the pipes are being screwed to the foundation with concrete screws. Most of the time this is not required. It is most common to dig 30" deep holes for each post. then fill the holes with a bag or so of concrete.
continue>>>>>

© 2005 Monumental Designs. All rights reserved.